This article mainly introduces:

Angola hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(Angola swager cylinder,produced by Hengyu Group）

swager cylinder are widely used in Angola，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed swager cylinder for customers from Angola.

Introduction to swager cylinder:

swager cylinder and hydraulic station selection: Select the type and structure of the swager cylinder according to the operation requirements of the main engine. According to the external load force borne by the swager cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the swager cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the swager cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the swager cylinder, the diameter of the piston and the piston rod.

swager cylinder buffer valve inspection and maintenance: For the valve buffer swager cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

swager cylinder hydraulic oil selection: The recommended working oil viscosity of the swager cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

The quality of the swager cylinder can not be ignored in the purchase of the swager cylinder. The swager cylinder is the main component of the swager cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. swager cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of swager cylinder is deep hole processing, which has always troubled the processing personnel.

Answers to some questions about swager cylinder:

Is there a national standard for the testing of hydraulic cylinders?
Generally speaking, the cylinder test is carried out according to JB/JQ20302 Allowable leakage of cylinder in pre-factory leakage test. GB2879 hydraulic cylinder piston and piston rod dynamic seal groove type, size and tolerance. GB6578 hydraulic cylinder piston rod dust ring groove type, size and tolerance. GB7938 hydraulic cylinder and cylinder nominal pressure series, etc.

Cylinder pressure calculation formula
The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate it according to the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the working pressure P (unit MPa) the thrust of the cylinder F push =3.14*R*R*P (unit N) The pulling force of the cylinder F pull =3.14* (R*R-r* R) *P (unit N).